SRT-8 Daytona Clone

With the hooks in a locked position I welded in a piece of 3/8" tubing to act as a stop on the rotation of the hooks so that when the seat back is lowered the shape of the bottom of the hook rolls the hooks open to then grab around the lower bar.

I then removed the entire device to paint it.

There is a side cover for all the switches to the seat which had to be modified in order for the seat back to rotate past it. I trimmed about an inch off of the rear side.

There were three attachment points for the plastic side cover and the rear was attached to the seat back so the plastic stud that located the screw had to be cut off.

Using a little double stick tape I placed the cut off stud temporarily to its old screw location.