SRT-8 Daytona Clone

The bolts ended up being a little two long in the tube and were causing a little drag so I shortened them up to about 2" and then place the assembly between the "L" brackets.

Once I was satisfied with the location of the tube I welded the ends to the "L" brackets to keep them from rotating leaving the center section to rotate and return with the springs.

I then welded another 3/4" tube with brackets to the lower section of the seat. After that was done I cut two hooks out of 3/16" flat steel. I rotated the center shaft to put it under tension and welded the hooks to the shaft.

I then added a "U" shaped handle so the whole thing could be rotated.