SRT-8 Daytona Clone

On the right side of the car I wasn't as lucky to have a roll pan corner to reference so I made two profile patterns of the left side and used them to guide me on the shape and location.
I then installed a new right side roll pan piece up to my templates.
The third picture is of the completed roll pan.
Next it was on to more rusty metal replacement on the upper tail light panel. This right side dished piece was a little tough to make without a planishing hammer. It is kind of small for the English wheel but that is what I had to use after metal shrinking the edges and using a mallet and a sand bag to work the depression.