Under the front of the car just behind the front wheel tub there was a plastic cover to protect the E brake cable. I had to make an abbreviated one out of black aluminum because of alterations to the chassis in this location.
Sunday, July 17, 2016
I messed around with a little badging on the rear wing. The SRT-8 logo that I ordered was cast metal and it was about 1/8" thick but fortunately it was hollow on the back. This allowed me to grind it off until it was only 1/16" thick so it lays nice and flat against the upright on the wing.
Under the front of the car just behind the front wheel tub there was a plastic cover to protect the E brake cable. I had to make an abbreviated one out of black aluminum because of alterations to the chassis in this location.
Under the front of the car just behind the front wheel tub there was a plastic cover to protect the E brake cable. I had to make an abbreviated one out of black aluminum because of alterations to the chassis in this location.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment