SRT-8 Daytona Clone

I put the new door seals on the back side of the door while I had it laying down. I had to make a couple of modifications to the seal due to the difference in the latch mechanisms and in the front where the vent window would normally go.
Also while I had it laying flat I glued in some sound deadener in the area of the door skin across from the door speaker to dampen vibrations on the skin.
I also took the time to run my wiring harness in the door while I had good lighting and could see all my attachment points.
After that I proceeded to hang the doors for the final time on the car. The last picture here shows the rubber boot for the door wiring harness installed for the last time.